Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Parts description
Light cover
1
Lamp housing
2
Wall plug
3
Wall bracket
4
Mains connection cord (external)
5
Protective tube
6
Junction box
7
Lustre terminal
8
Screw (lamp housing)
9
Silicone ring
10
Screw (wall bracket)
11
Membrane
12
Metal covers
13
Washer
14
Technical data
Item no.:
14130706L / 14130705L /
14130806L
Operating voltage: 230 - 240 V ~ 50 Hz
Nominal voltage:
LED max. 7.5 W (LEDs are not
replaceable.)
Protection class:
II /
Protection type:
IP44
Safety
Safety notices
Damage due to failure to comply with these operat-
ing instructions will invalidate the warranty! We
assume no liability for consequential damage! We
assume no liability for material damage or personal
injury due to improper handling or failure to comply
with the safety instructions!
DANGER TO LIFE AND ACCI-
DENT HAZARD FOR TODDLERS
AND SMALL CHILDREN!
Never leave children unattended with the
packaging material. The packaging material
represents a danger of suffocation. Children
frequently underestimate the dangers. Please
Introduction / Safety
keep children away from the product at all
times.
Danger to life from
electric shock!
Ensure that a qualified electrician, or a person
trained to carry out electrical installations, per-
forms the electrical installation.
We assume no liability for material damage or
personal injury due to improper handling or
failure to comply with the safety instructions!
Never use the light if any defects have been
identified.
Prior to installation, remove the fuse or switch
off the circuit breaker (0 setting) in the fuse
box. Set the light switch to the "OFF" position.
Prior to installation, verify that the mains voltage
on site corresponds with the operating voltage
required for the light (see "Technical Data").
Before drilling, ensure that there are no gas or
water pipes or cables where you intend to drill.
Installation may only be carried out by experts.
It is essential that you take note of the wall
quality, as the included fittings are not suitable
for all types of wall.
It is essential that you take note of the wall
quality, as the included fittings are not suitable
for all types of wall.
The manufacturer accepts no responsibility for
an inappropriate wall plug connection and any
resulting damage.
The illuminant in this light cannot be replaced.
If the illuminant has reached the end of its life,
the entire light must be replaced.
Risk of burns and injury!
Do not install the light, if it has a defective lamp
glass. In this case contact the service centre for
a replacement.
Only install the light on normally inflammable
or non-inflammable surfaces. Excessive heat can
result in a fire.
Never open any of the electrical equipment or
insert objects into these. This will pose the risk
of fatal injury from electric shock.
GB/IE
13
Werbung
