Cleaning The Milk Foaming Unit Following Its Last Use - K-FEE LATTENSIA Betriebsanleitung

1 2
Allow the milk foaming Take the milk foaming unit apart as illustrated.
unit to cool down and
then remove it from
the steam outlet.
4
no milk residue remains and dries on.
ing recommendations in these operating instructions (p. 58 – 61). Please be
aware that the milk foaming unit contains parts which are subject to wear
Assemble the milk
(air intake nozzle and milk suction hose) over time. Depending on the us-
foaming unit and push
age and cleaning pattern this can lead to a situation where only very little
it on to the steam
or no milk can be frothed up. Should you need replacement parts please
outlet.
contact our customer service (p. 73).
If the milk foaming unit is not used within 5 minutes following
the last use it has to be cleaned thoroughly. To do that the milk
foaming unit has to be taken apart and the parts cleaned so that
WARNING
The milk foaming unit must be cleaned regularly to ensure that it
functions properly. For this purpose please take note of the clean-
3
Thoroughly rinse the
parts with hot water
and allow to dry indi-
vidually before assem-
bling them.
Cleaning the milk
foaming unit follow-
ing its last use
We recommend this
thorough cleaning of
the milk foaming unit
after every use because it is
difficult to remove milk resi-
dues. First place the parts into
hot water in order to soften the
milk residues.
Reassemble the milk
foaming unit again
carefully following
each disassembly and attach it
to the steam outlet. All parts of
the milk foaming unit have to
be firmly put together again so
that it functions properly.
EN
59