Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Setting the electrical support level
You can use the controls to determine how much
the e-bike electrical support will assist you when
pedalling. The electrical support level can be
changed at any time, even while riding.
The following electrical support levels are available:
• "OFF"The electrical support is switched off
and the e-bike can be moved by pedalling only,
like a normal bicycle. All other functions (e.g.
lighting) are still available.
• "ECO": Effective electrical support with maxi-
mum efficiency to achieve maximum range
• "TOUR": Continuous electrical support for
trips with a large range
• "SPORT": Powerful electrical support for ath-
letic riding on mountainous routes as well as
in city traffic
• "TURBO": Maximum electrical support up to
high pedalling frequencies for athletic riding
Increase the electrical support level by pressing
the "+" button 13 on the operating unit until the
desired electrical support level is shown at Indica-
tor b or lower the value by pressing the "–" but-
ton 12. The motor power requested is shown on
the display a. The maximum motor performance
depends on the electrical support level chosen.
14
13
10. Control panel
11. The "i" button on the control unit activates
the display function.
12. Reduce value/scroll down "–" button
13. Increase value/scroll up "+" button
14. Pushing aid button "WALK"
Switching the pushing/ start-up aid on and off
The pushing/ start-up aid can make it easier for
you to push the e-bike or get it moving. Do not use
the pushing aid to ride the bike.
FLYERS with pedalling support up to 25 km/h are
equipped with a pushing aid. This is limited to 6
km/h in the fastest gear. The FLYER can con-
veniently be moved out of underground parking or
along steep paths by pressing the "WALK" button
14. The "WALK" button allows models with pedal-
ling support above 25 km/h to activate the start-up
aid, which is restricted to 18 km/h. The installation is
performed in compliance with national regulations.
The pushing aid is switched on by pressing the
"WALK" button 14 on the operating unit and holding
10
11
12
it down. The e-bike electrical support function is
switched on.
The pushing aid is switched off as soon as one of
the following events occurs:
• You release the "WALK" button 14,
• The wheels of the e-bike are blocked (e.g. by
breaking or bumping against an obstacle)
• speed exceeds 6 km/h or 18 km/h
Switch lighting on/off
The headlight and the rear light can be switched
on and off at the same time by pressing the but-
ton 2 on the controls when the respective bicycle
version supplies the riding lights from the e-bike
system. The daytime running light is activated
when riding at a variant speed. The lighting will
automatically turn on when you switch on the sys-
tem. The button 2 will not turn off the light.
Gear Recommendation
If the notification "g" is displayed, you should shift
into a higher gear and pedal at a lower cadence.
If the notification "h" is displayed, you should shift
into a lower gear and pedal at a faster cadence.
Battery charge status indicator
The battery charge status indicator i shows the
charge status of the e-bike battery and not that of
the internal controls' battery.
The charge status of the e-bike battery can be
read on the battery itself.
Each bar on the battery symbol i corresponds to
approx. 20% capacity:
The battery is fully charged.
The battery should be topped up.
The charge for electrical support is used
up and the electrical support function
will gently switch off. The remaining capacity is
provided for the lighting and the controls, the dis-
play flashes. The battery will still provide approx.
2 hours of lighting.
Checking the battery before its first use
Check the battery before you charge it or use it
with your e-bike for the first time.
Press the A4 on/off button to switch on the bat-
tery. The battery may be damaged when no LED
on the charge status indicator A3 lights up. If
at least one (but not all) of the LEDs is lit in the
A3 charge level indicator, then you need to fully
charge the battery before use.
The battery may not be recharged when
it indicates a fault. The battery might be
damaged after being dropped or due to
mechanical impact, even when there is
no visible external damage. Such
128
Werbung
