Operation; Working Notes - Grizzly MTS 30-10 E2 Originalbetriebsanleitung

the throttle lock and the throttle. The half-
throttle lock is engaged.
7. Hold the equipment firmly with one
hand on the top shaft tube (10). With
the other hand, pull the starter cable
several times on the starter handle (3)
until the engine starts.
Caution! Do not pull the starter ca-
ble out too far – risk of breaking!
8. Allow a cold motor to warm up for ap-
prox. 10 seconds then set the choke
lever (4) to the "warm start" position.
9. If the equipment does not start, repeat
stages 3 to 5.
10. Attach the equipment to the carry-
ing strap that has been put on (see
chapter on "Putting on the Carrying
Strap").
11. To mow, hold the throttle lock (41) de-
pressed and operate the throttle (42).
12. To switch off the engine, set the on/off
switch (40) 0 .
pic. 10
40
41
43
42
3
10
3

Operation

Working Notes

•
•
•
•
21
Work safely and considerately!
• Always hold the equipment firmly and
• Cut only grass and weeds. Be aware of
4
• Work considerately and endanger no-
• Work only in adequate visibility and
• Keep an eye on the cutting head.
• Never cut above shoulder height.
• Never replace the plastic cord with a
10
• Do not work on a ladder.
• Work only on firm and stable bases.
• Always carry the equipment suspended
If the engine fails to start after a
second attempt, try to start it in the
"warm start" position without the
choke.
If this is unsuccessful, follow the
instructions in the chapter on
"Troubleshooting".
When cutting, observe the country-
specific / local regulations.
Do not cut during commonly applica-
ble quiet periods.
Solid objects such as stones, metal
pieces or similar must be removed.
These can be thrown out and there-
fore result in personal or property
damage.
When cutting in high bushes or hedg-
es, the working height should be at
least 15 cm. This prevents the risk to
animals, e.g. hedgehogs.
securely with both hands (see picture
8).
roots or tree stumps – risk of tripping.
body when cutting. Work quietly and
carefully.
lighting conditions.
steel wire – risk of injury and damage.
by the shoulder strap or on the tube
GB
103