Toro 21026 Bedienungsanleitung Seite 7

5. Installing the Fuse
Procedure
Model 21027 only
Your mower comes with a 40-amp fuse that protects the
electric starter.
Important: You cannot start the mower with the
electric starter or charge the battery unless you
install the fuse.
1. Open the battery cover (Figure 9).
1. Battery cover
2. Fuse holder
2. Locate the fuse holder from the upper left corner of
the opening to the battery compartment (Figure 9).
Note: The wire to the fuse holder is short; you will
not be able to pull the fuse holder fully out of the
battery compartment.
3. Install the fuse in the fuse holder (Figure 10).
Figure 9
3. Fuse
Figure 10
Note: Your mower comes with a fuse in the your
owner's packet.
4. Install the battery cover.
6. Charging the Battery
Procedure
Model 21027 only
Refer to Charging the Battery in the Maintenance
section.
Product Overview
Model 21027 shown
1. Lower handle lock (2)
2. Grass bag
3. Upper handle lock (2)
4. Recoil start handle
5. Traction assist handle
(Models 21026 and 21027
only)
6. Blade control bar
7. Ignition key (model 21027
only)
7
Figure 11
8. Rear door
9. Cutting height adjustment
handle
10. Oil fill/Dipstick (not shown)
11. Fuel tank cap
12. Spark plug
13. Air filter
14. Recycling/bagging lever