Toro 21026 Bedienungsanleitung Seite 11

of the Recycling/bagging lever and move the lever
to the bagging mode (Figure 19).
Installing the Grass Bag
1. Stop the engine and wait for all moving parts to stop.
2. Raise and hold up the rear door, install the bag on
the handle, and lower the rear door (Figure 20).
Removing the Grass Bag
1. Stop the engine and wait for all moving parts to stop.
2. Lift up the grass bag up and away from the handle.
Note: Tilt the grass bag slightly backward to prevent
the collected grass clippings from falling out.
Figure 20
Rear-discharging the
Clippings
Use the rear discharge for cutting very tall grass.
If the bag is on the mower, remove it (refer to Removing
the Grass Bag) before rear-discharging the clippings
(Figure 21).
Note: The Recycling/bagging lever should be in the
bagging mode (Figure 19).
The blade is sharp; contacting the blade can
result in serious personal injury.
Stop the engine and wait for all moving parts to
stop before leaving the operating position.
Operating Tips
General Mowing Tips
• Clear the area of sticks, stones, wire, branches, and
other debris that the blade could hit.
• Avoid striking solid objects with the blade. Never
deliberately mow over any object.
• If the mower strikes an object or starts to vibrate,
immediately stop the engine, disconnect the wire
from the spark plug, and examine the mower for
damage.
• For best performance, install a new blade before the
cutting season begins.
• Replace the blade when necessary with a Toro
replacement blade.
Cutting Grass
• Cut only about a third of the grass blade at a time.
Do not cut below the C setting unless the grass is
11
Figure 21