Parkside Performance PSBSAP 20-Li B3 Originalbetriebsanleitung Seite 18

Safety guidelines for battery
chargers
This tool may be used by children
■
aged 8 years and above and
by persons with limited physical,
sensory or mental capabilities or
lack of experience and knowl-
edge, provided that they are
under supervision or have been
told how to use the tool safely
and are aware of the potential
risks. Do not allow children to
use the tool as a toy. Cleaning
and user maintenance tasks may
not be carried out by children
unless they are supervised.
To avoid potential risks, dam-
■
aged mains cables should be re-
placed by the manufacturer, their
customer service department or
a similarly qualified person.
The charger is suitable for indoor use
only.
WARNING!
■ To avoid potential risks, damaged mains cables
should be replaced by the manufacturer, their
customer service department or a similarly
qualified person.
ATTENTION!
♦ This charger can only charge the following
batteries: PAP 20 A1/PAP 20 A2/
PAP 20 A3/PAP 20 B1/PAP 20 B3/
PAPS 204 A1/PAPS 208 A1.
♦ A current list of battery compatibility can be
found at www.Lidl.de/Akku.
PSBSAP 20-Li B3
Before use
Charging the battery pack
(see fig. A)
CAUTION!
► Always unplug the tool before you remove
the battery pack from or connect the battery
pack to the charger.
NOTE
► Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is going to be stored
for an extended period, the charge level
should be checked regularly. The optimum
charge level is between 50% and 80%. The
storage climate should be cool and dry and
the ambient temperature should be between
0°C and 50°C.
♦ Connect the battery pack e to the high-speed
charger t (see fig. A).
♦ Insert the power plug into the socket. The green
charge control LED o lights up briefly, then the
red charge control LED i lights up.
♦ The green charge control LED o indicates
that the charging process is complete and the
battery pack e is ready for use.
ATTENTION!
♦ If the red charge control LED i flashes,
this means that the battery pack e has
overheated and cannot be charged.
♦ If the red and green charge control LEDs i/
o both flash, this means that the battery
pack e is defective.
♦ Push the battery pack e back into the tool.
♦ Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
GB │ IE │ 7 ■