Parkside PPMA 20-Li B2 Originalbetriebsanleitung Seite 25

consult their doctor and the manu-
facturer of their medical implant
before operating the machine.
Preparation
Removing/inserting the bat-
tery
1. To remove the battery (7) from the de-
vice, press the release button (6) on the
battery and pull the battery (7) out.
2. To insert the battery (7), push the bat-
tery (7) along the guide rail into the
device. You will hear it click into place.
Only insert the battery once
the battery-operated tool is
fully ready for use.
Checking the charge status
of the battery
The charge level indicator (9) signals the
state of charge of the battery (7) by illu-
minating the corresponding LED(s). To see
this, press the soft button (8) next to the
charge level indicator (9).
3 LEDs illuminated (red, orange and green):
Battery charged
2 LEDs illuminated (red and orange):
Battery partially charged
1 LED illuminated (red):
Battery needs to be charged
Charging the battery
If warm, allow the battery to cool
before charging.
1. If necessary, remove the battery (7)
from the device.
2. Slide the battery (7) into the charging
slot of the charger.
3. Plug the charger into a socket.
4. Once charging is complete, disconnect
the charger from the mains supply.
5. Remove the battery (7) from the charger.
Attaching the polishing pad
to the polishing disc
1. Align the polishing disc (3) upwards.
2. Grasp a terry cloth polishing pad (5) or
a synthetic polishing pad (4) with both
hands and widen the elastic outwards.
3. Place the polishing pad (4/5) over the
edge of the polishing disc (3) at one point.
Pull the pad all the way around the edge.
4. Pull the polishing pad (4/5) centred
and tight onto the polishing disc (3).
Operation
Switching on and off
1. Insert the battery (7).
2. To switch on, tilt the on/off switch (2) to
position „I", the device turns on.
3. To switch off, tilt the on/off switch (2) to
position „0", the device turns off.
4. Firmly hold the device with both hands
on the handle (1).
The speed can be set using the
wheel on the front of the device.
Waxing/polishing paint
surfaces
1. Use the terry cloth polishing pad (5) for
applying polish.
2. Apply the wax or polish on a slightly
smaller area than the area you would
like to polish.
GB MT
25