Kärcher Puzzi 400 E Bedienungsanleitung Seite 11

English
Cleaning
Actuate the valve handle
The cleaning agent solution is
sprayed and simultaneously sucked
in.
Drive on the surface to be cleaned in
overlapping paths. Repeat as
necessary.
Note:
When the dirty-water tank is full, the
suction air is interrupted by the
mechanical floating switch.
¾
Switch off spray and suction
switch
¾
Remove the cover
¾
Remove dirty-water tank (1) and
empty, or empty using a drain
hose (2)
Puzzi 400 E
CLEANING METHODS
Normal dirty carpets
• Spray cleaning solution and use
suction immediately
• Using suction again shortens the
drying time
Very dirty carpets
• Only spray cleaning solution
• Wait 10-15 min.
• Use suction to remove cleaning
solution
Cleaning upholstery
• Attach the hand nozzle (special
attachment) instead of floor nozzle
for cleaning upholstery
• Use the appropriate attachments
for cleaning steps, wall carpets, or
motor vehicle-interiors
• For sensitive materials use lower
amounts of the cleaning agent,
spray the surface from
approx. 200 mm away. Use
suction afterwards to remove
solution
Rinsing
• One obtains a better result when
the surface to be cleaned is rinsed
again with clear water
• Remains of the cleaning agent
and loosened dirt are then rinsed
out
Working tips
• The more sensitive the carpet, the
smaller the amount of cleaning
agent
• Carpets with jute backings can
shrink and the colours can bleed if
the treatment is too wet
• High pile carpets should be
brushed off first
• Cleaning with warm water (up to
max. 75°C) is more effective.
Check the temperature stability of
the surface to be cleaned.
• Spray very dirty areas beforehand
• Work from light to dark areas
(from window to doors)
• Work from clean areas to dirty
ones
• Treat carpet with
Care Tex RM 762 after cleaning
(accessory).
• Wait until cleaned surface is dry
before walking on it
• Use de-foaming agent
RM 761 (accessory) for
shampooed carpets.
11