LSL 118KT15 Montageanleitung Seite 6

Assembly left side:
Step 1:
Mount rear set at main frame with M8x18 (20Nm) and use bolt adhesive.
Step 2:
Mount foot peg with M5 x 25mm (6Nm) and use bolt adhesive.
Step 3:
Determine the position of the rear set, then tighten the two bolts M8x20 (20Nm) of the
adjustment plate.

choice of thread rod
6 x 40mm thread rod:
6 x 60mm thread rod:
Step 4:
Use determined thread rod. Turn it incl. bolt adhesive into joint ball until the end.
Put hexagon nut loose on the thread rod. Turn the other side into shifting rod.
Step 5:
Adjust the shifting lever by turning the shifting rod into your favorite position. Connect joint
ball to the gearbox lever with M6x16. Now tighten both hexagon nut to block thread rod.
2 x M8x18 (20Nm)
main frame bolts
joint ball with
bolt M6x16
6x60mm or
6x40mm thread rod
with hexagon nut
——————————————
Rev. 01 14/03/2016
1. Position front side, top slot.
1. + 2. Position front side, lower slot
2. + 3. + 4. Position front side, top slot.
3. + 4. Position front side, lower slot.
hexagon nut
shifting rod
Zubehör von
2 x M8x25 (20Nm)
tighten in your determined position
foot peg with M5x25 (6Nm)
close with plastic plug
—
Das Original
——
Seite 6 von 8