Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
DESCRIPTION
Quick-warming sauna unit with overheating
protection and three-phase connection.
Adapted for wall mounting. Sauna stones sold
separately.
1.
Temperature limit
2.
Power switch
3.
Thermostat
4.
Junction box
5.
Power cord
6.
Mains box
7.
Connection leads
FIG. 1
INSTALLATION
Minimum distance (mm)
A
B
100
100
Sauna volume
Min (m
)
3
5
•
Mount the sauna unit on the wall with the
supplied screws.
•
The unit can be mounted in a recess with
a minimum height of 1900 mm.
•
Do not cover the wall behind the sauna
unit with material such as asbestos or fibre
cement, this can result in overheating.
•
Walls and ceiling must be made of
suitable heat-resistant material.
FIG. 2
FIG. 3
20
C
280
Min height
Max (m
)
3
(cm)
9
190
FIG. 4
FIG. 5
USE
PREPARATIONS
Mount the sauna unit and control unit, and
place 10–15 kg suitable stones in the sauna
unit.
IMPORTANT:
•
Only use stones that can withstand the
hot temperature of the sauna unit.
Stones that cannot withstand high
temperatures and intense heat
exchange will crack or crumble and can
damage the heater element or cause
corrosion, which will reduce the
circulation of heat during the heating
and when water is poured on the sauna
unit to produce steam.
•
Only use fresh tap water. Other
D
substances can damage the heater
element if poured over the stones.
150
•
The first time the sauna unit is used it
can smell and smoke a little when the
rust protection oil is burned off the
heater element. This is perfectly normal
and stops after about 10 minutes.
BEFORE USING FOR THE FIRST TIME
The first time the sauna unit is used it can
smell and smoke a little when the rust
protection oil is burned off the heater element.
This is perfectly normal and stops after about
10 minutes.
SAFETY RAIL
Note the minimum distance as shown in figure
6 when mounting a safety rail.
FIG. 6
Werbung
