Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4
Correct Disposal Of This Product
This marking indicates that this product should not be disposed with other household wastes throughout
EN
the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable reuse of material resources. To return your used device,
please use the return and collec琀椀on systems or contact the retailer where the product was purchased.
They can take this product for environmental safe recycling.
Gas Cylinder
Use only gas cylinders, which meet na琀椀onal and regional codes. For op琀椀mal performance the grill should
be operated on propane. The minimum cylinder size for butane units is 13kg, and for propane units is 6kg.
Ensure that the cylinder can provide enough fuel to operate the appliance. If in doubt, check with your
local gas supplier.
Use cau琀椀on when handling the cylinder valve.
•
Never connect a cylinder, which does not meet local codes.
•
Only cylinders connected to the appliance may be stored in the enclosure, or close to the appliance.
•
Enclosures must comply with the BUILT IN CYLINDER ENCLOSURES paragraph in the following sec琀椀on.
Spare cylinders must not be stored in the enclosure, or in close proximity of an opera琀椀ng unit. Cylin-
ders must not be exposed to extreme heat or direct sunlight.
Cylinder Connec琀椀on: Remove the cap or plug from the cylinder fuel valve. Tighten regulator to cylinder
valve. Leak test all joints prior to using the barbecue. A leak test must be performed annually, and each
Example Cylinder
Gas Hose
WARNING!
!
connected to the gas supply using hoses except to connect the cylinder regulator to the piping system.
The increased temperature within the enclosure may cause the hose to melt. Use the provided 昀氀exible
metal connector to connect the gas grill to either approved rigid piping, approved copper tubing or
approved 昀氀exible metal connectors. Ensure the installa琀椀on conforms to all local and na琀椀onal codes.
The en琀椀re gas supply installa琀椀on must be leak tested before opera琀椀ng the gas grill. Refer to the
manual for complete grill assembly instruc琀椀ons.
If the hose and regulator are not included by the manufacturer, then only hoses and regulators which
•
meet na琀椀onal and regional codes are to be used.
Ensure that the hose does not come into contact with grease, other hot drippings, or any hot surfaces
•
on the appliance.
Check hose regularly. In the case of rips, mel琀椀ng or wear, replace hose before using the appliance.
•
•
The recommended hose length is 0.9m. The hose must not be longer than 1.5m.
Ensure that the hose is twist and kink free when installed.
•
•
Replace the hose before expiry date printed on the hose.
www.napoleon.com
琀椀me a cylinder is hooked up, or if a part of the gas system is replaced.
306 mm
465 mm
This gas grill must be installed by a licensed gas 昀椀琀琀er. The gas grill can not be
N415-0542CE-GB-DE FEB 01.22
Werbung
