Werbung
®
R&S
RT-ZD40
All settings of the base unit described in this section refer to the R&S
RTO/RTE oscilloscopes. If any other oscilloscope is used, differences in
settings and menu navigation may be possible.
2.1.1
Connecting the Probe to the R&S RTx Oscilloscope
The R&S RT-ZD40 differential probe has been designed for use with R&S RTx
oscilloscopes.
► Connect the probe box (1) to the Rohde & Schwarz probe interface of the
base unit (2). The probe will snap in when connected properly to the port.
Fig. 2-1: Connecting the probe to the R&S RTO oscilloscope
► To disconnect, press the release button (3) and pull the probe box away from
the front panel of the base unit.
2.1.2
Identification of the Probe
When the probe is connected to the oscilloscope, the oscilloscope recognizes the
probe and reads out the probe-specific parameters.
The oscilloscope settings for attenuation and offset are automatically adjusted.
User Manual 1410.5363.02 ─ 03
Putting into Operation
Installation
16
Werbung
