ABB ACH580-34 Kurzanleitung Für Die Installation Und Inbetriebnahme Seite 19

Use the control panel to do the start-up procedure. The two commands at the bottom
of the display (Options and Menu) show the functions of the two softkeys
located below the display. The commands assigned to the softkeys are different
depending on the context. Use the arrow keys , ,
change values depending on the active view. The key
page.
1.
Power up the drive. Make sure
that you have the motor name-
plate data available.
Select the language you want to
use and press (OK).
Note: After you select the lan-
guage, it takes a few minutes for
the control panel to wake up.
4.
In the Main menu, go to Parameters > Complete list > 95 HW config-
uration by pressing (Select) repeatedly. Select 95.01 Supply
voltage and press
(Save).
6.
To complete the First start assist-
ant, select the values and settings
when prompted by the assistant.
Continue until the panel shows
that the first start is complete.
When the panel shows that the
first start is complete, the drive
is ready for use. Press
to enter the Home view.
2.
In the First start assistant screen,
select Not now and press
(Next).
(Edit). Select supply voltage and press
7.
The Home view monitors the val-
ues of selected signals.
(Done)
EN – Quick installation and start-up guide 19
and to move the cursor or
?
shows a context-sensitive help
3.
In the Home view, press
(Menu) to enter the Main menu.
5.
Go back to the Main menu by
pressing
In the Main menu, select First
start assistant and press
lect). In the First start assistant,
select Commission the ACH580
and press
8.
Make additional adjustments
starting from the Main menu.
Press (Menu) in the Home
view to enter the Main menu.
Select Primary settings and press
(Select).
To get more information on the
Primary settings menu items,
?
press to open the help page.
and
EN
DA
DE
ES
FI
FR
IT
NL
(Back) repeatedly.
PL
(Se-
PT
(Next).
SV
TR
ZH