Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Manual focus adjustment
1. Loosen the focus fixation screw on the side of
the device.
2. Adjust the focus by sliding the fixation screw
forwards or backwards.
3. Tighten the focus fixation screw on the side of
the device.
Manual zoom adjustment
1. Loosen the zoom fixation screw on the side of
the device.
2. Adjust the zoom by sliding the fixation screw
forwards or backwards.
3. Tighten the zoom fixation screw on the side of
the device.
Master/slave operation
Note: To connect multiple devices in series, please use the supplied Y-XLR adapter cable. (See chapter
Accessories).
Master-slave connection for multiple devices via supplied Y-XLR adapter cable (see graphic):
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled with the
master unit without the need for a DMX controller. The devices must be set to the corresponding operating modes.
1
Configure all slave units before connecting the master unit. For this, set each Slave device to the same DMX
address (for example 001) and confirm with ENTER.
2
Connect the F-socket of the Y-XLR adapter cable to the first device. Another Y-XLR adapter cable (M-plug) can
be attached to the second F-socket.
3
In this way, you can connect the devices in the chain until all devices are connected.
4
Make sure the master unit is the first in the chain. Do not connect a DMX controller to the DMX input of the
master unit.
5
Select the desired mode at the master unit (See Menu Structure). The interconnected devices will now operate
synchronously.
M
Note: When not in use, be sure to close the unused plug or socket with the supplied rubber sealing cap to prevent
moisture and dirt from entering.
F
F
M
24/28
Focus
F
M
F
Zoom
F
F
00147165.DOCX, Version 1.0
Werbung
