Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Inserting/Exchanging gobos
If you wish to project a gobo pattern, please follow the instructions below:
1. Loosen the two screws on the metal plate in front of the gobo holder slot
and slide the plate slightly forward (See graphic).
2. Carefully insert the gobo holder with the desired gobo into the gobo
holder slot.
3. Carefully slide back the metal plate and tighten the screws.
INSTALLATION
WARNING! Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure that the
device is installed securely and cannot fall down. The installation must be carried out by a specialist who
is familiar with the hazards and the relevant regulations.
The device may be placed on the floor or fastened to a truss or similar rigging structure. The device must never be
fixed swinging freely in the room.
1
The rigging structure must support at least 10 times the
weight of all fixtures to be installed on it.
2
Block access below the work area and work from a stable
platform when installing the device.
3
Use rigging hardware that is compatible with the structure and
capable of bearing the weight of the device. Please refer to
the "Accessories" section for a list of suitable rigging
hardware.
4
Secure the device with a safety bond or other secondary
attachment. This secondary safety attachment must be
sufficiently dimensioned in accordance with the latest
industrial safety regulations and constructed in a way that no
part of the installation can fall down if the main attachment
fails. An appropriate eyelet is mounted on the device for
fixation of the safety bond. Fasten the safety bond in such a
way that, in the event of a fall, the maximum drop distance of
the device will not exceed 20 cm.
5
To align the device, release the fixation screws at the
mounting bracket, adjust the desired inclination angle and
tighten the fixation screws.
6
After installation, the device requires inspections periodically
to prevent the possibility of corrosion, deformation and
looseness.
20/28
00147165.DOCX, Version 1.0
Werbung
