Herunterladen Diese Seite drucken

EuroLite LED IP PFE-40 CW/WW 15-30 Bedienungsanleitung Seite 23

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

OPERATION
After connecting the device to the mains it is ready for operation. The operating modes can be selected by means
of the display and the control buttons. All settings remain stored even if the device is disconnected from the mains.
The device can be operated in stand-alone mode via the control board or in DMX-controlled mode via any
commercial DMX controller.
Press the MENU button to access and browse through the main menu. Press the ENTER button in order to select
the desired menu item. You can change the selection by pressing UP or DOWN. Confirm every selection by
pressing the ENTER button. The functions provided are described in the following sections.
Menu structure
Default settings shaded
Main Menu
A001
CHnL
Fail
dinn
Strb
uL--
cL--
nodE
tEnP
UErn
rSEt
PnnF
0.6F / 1.2F / 2.0F / 4.0F /
Stand-alone mode
In stand-alone mode, the device can be used without controller. Disconnect the device from the controller and call
up the menu you want to use. Please refer to the instructions under Menu structure.
Sub menu
Function
001 - 512
Setting the DMX starting address
Setting DMX Mode
1CH
1-Channel DMX Mode
2CH
2-Channel DMX Mode
3CH
3-Channel DMX Mode
6CH
6-Channel DMX Mode
DMX Lost Mode
Hold
Most recent DMX value is held
Full
All LEDs 100% on
Blnd
LEDs switched off
Master Dimmer (Master Mode)
000 - 255
Total brightness 0 – 100%
Strobe (Master Mode)
S.00 - S.20
Increasing speed
Dimmer (Master Mode)
u.000 - u.255
WW increasing brightness 0 – 100%
c.000 - c.255
CW increasing brightness 0 – 100%
Dimmer speed (step response)
nod.0
Response characteristics of LEDs: No delay
Response characteristics of halogen lamps, fast
nod.1
Response characteristics of halogen lamps, less fast
nod.2
Response characteristics of halogen lamps, middle
nod.3
Response characteristics of halogen lamps, slow
nod.4
t---
Inner temperature
xxx
Software Version
Restore factory settings
Pulse-width modulation
With this function, the PWM frequency of the LEDs can
be set: 600Hz, 1200Hz, 2000Hz, 4000Hz, 12000Hz,
12F / 24F
24000Hz
23/28
00147165.DOCX, Version 1.0

Werbung

loading

Diese Anleitung auch für:

Led ip pfe-40 cw/ww 25-504000170540001706