EINHELL 43.403.10 Bedienungsanleitung Seite 15

Anl. TKS 250, neue ET!!
1. Description (Fig. 1/2)
1 Saw table
2 Saw blade guard
3 Push stick
4 Saw blade
5 Splitter
6 Table insert
7 Parallel stop
8 Handwheel
9 Power cable
10 Stand
11 On/Off switch
12 Star-grip screw
13 Vacuum extraction pipe
14 Cross stop
15 Wing nut
16 Vacuum extraction adapter
21 Screw
2. Items supplied
Bench-type circular saw
Carbide-tipped saw blade
Parallel stop
Cross stop
Push stick
Face spanner
Open-ended spanne
3. Proper use
The TKS 250 bench-type circular saw is designed for
the slitting and cross-cutting (only with the cross
stop) of all types of timber, commensurate with the
machine's size.
The machine is not to be used for cutting any type of
roundwood.
The machine is to be used only for its prescribed
purpose.
Any use other than that mentioned is considered to
be a case of misuse. The user/operator and not the
manufacturer shall be liable for any damage or injury
resulting such cases of misuse. The machine is to be
operated only with suitable saw blades (carbide or
chrome-vanadium blades). It is prohibited to use
HSS blades and any type of cutting-off wheel.
To use the machine properly you must also observe
the safety regulations, the assembly instructions and
the operating instructions to be found in this manual.
The manufacturer shall not be liable for any changes
made to the machine nor for any damage resulting
from such changes.
20.07.2004 7:34 Uhr Seite 15
Even when the machine is used as prescribed it is
still impossible to completely eliminate certain
residual risk factors. The following hazards may arise
in connection with the machine's construction and
design:
Contact with the saw blade in the uncovered
saw zone.
Reaching into the running saw blade (cut
injuries).
Kick-back of workpieces and parts of workpieces
due to improper handling.
Saw blade fracturing.
Catapulting of faulty carbide tips from the saw
blade.
Damage to hearing if essential ear-muffs are not
worn.
Harmful emissions of wood dust when the
machine is used in closed rooms.
4. Important notes
Please read this manual carefully and pay attention
to the information provided. Use this manual to
familiarize yourself with the machine, its correct use
and safety regulations.
Safety regulations
Caution: Whenever electric tools are used it is
imperative to take the basic safety precautions
in order to rule out risks of fire, electric shock
and injury to persons.
Keep these safety instructions in a safe place.
Always pull the plug out of the power socket
before adjusting or servicing the machine.
Give these safety regulations to all persons who
work on the machine.
Do not use this saw to cut fire wood.
Do not use this saw to cross-cut roundwood.
Caution! Hands and fingers may be injured on
the rotating saw blade.
The machine is equipped with a safety circuit-
breaker (11) to prevent it starting up again after
a voltage drop.
Before you use the machine for the first time,
check that the voltage marked on the rating plate
is the same as your mains voltage.
If you need to use an extension cable, make
sure its conductor cross-section is big enough
for the saw's power consumption. Minimum
cross-section: 1 mm 2 .
If you use a cable reel, the complete cable has
to be pulled off the reel.
Do not carry the machine by ist power cable.
Check the power cable (9). Never use a faulty or
damaged power cable.
GB
15