ROSE SNEAK Bedienungsanleitung Seite 36

3.5 Setting the saddle height
DANGER
Raising the seat post above the insertion mark or inserting it below the mark may cause accidents or damage!
If the seat post is not inserted to the minimum insertion mark, it may break or damage the frame.
• The seat post must not be extended further than the limit mark!
• When cutting down the seat post, the original minimum insertion mark is no longer valid. Make sure to insert the
seat post at least 10 cm into the frame.
1. Open the saddle clamp.
2. Change the height of the saddle by sliding the seat post up or down and make sure the saddle is straight.
→ The seat post must not be raised above or inserted below the minimum insertion line marked on the seat post.
3. Tighten the clamp bolt to a torque of 4 Nm.
4. Get on your bike and check whether the seat post height is right.
36
4 Nm
MIN