Belden Hirschmann GRS106 HiOS-3A-UR Referenzhandbuch Seite 1176

Tab. 88:
Byte Content
13 Module removal
14 ACA removed
15 Not used
16 Not used
17 Connection
Tab. 89:
Byte Content
0 Report port error
1 Report connection error
2 Transmission rate too high
Anmerkung: Die Konfigura-
tion dieses Parameters ist
möglicherweise nicht im TIA-
Portal verfügbar.
3 Port on
4 Link status
5 Bit rate
6 Duplex
UM Config GRS106 HiOS-3A
Release 9.4 07/2023
Gerätestatus
Access
ro
ro
ro
Port-Status/Port-Parameter
Value Meaning
0 Unavailable
1 OK
2 A module has been removed.
0 Unavailable
1 OK
2 The ACA has been removed.
0
1
2
0
1
2
0 Unavailable
1 OK
2 Connection failure
Access Value Meaning
rw 0 Do not send an alarm
1 When one of the port alarm reasons
represented by bytes 4 .. 10 occurs,
send an alarm.
rw 0 Do not send an alarm
1 Send alarm if the connection has failed.
rw 0 Do not send an alarm
1 When the threshold values for the
transmission rate are exceed, send an
alarm.
rw 0 Unavailable
1 Port enabled
2 Port disabled
ro 0 Unavailable
1 Connection exists
2 Connection interrupted
ro 0 Unavailable
1 Unknown
2 10 Mbit/s
2 100 Mbit/s
2 1000 Mbit/s
ro 0 Unavailable
1 Half-duplex
2 Full-duplex
Industrieprotokolle
17.3 Funktion PROFINET
521