Belden Hirschmann GRS106 HiOS-3A-UR Referenzhandbuch Seite 1106

Tab. 71:
Id Attribute
0x2 Interface Flags
0x3 Physical Address
0x4 Interface Counters Get
0x5 Media Counters
0x6 Interface Control
0x7 Interface type
0x8 Interface state
0x9 Admin State
0xA Interface label
UM Config GRS106 HiOS-3A
Release 9.4 07/2023
Instanz-Attribute (Forts.)
Access
Rule
Get
Get
Get
Get/Set STRUCT of:
Get
Get
Set/Get USINT
Get
Data type Description
DWORD Interface Status Flags:
0:
1:
2:
3:
4:
5:
6:
ARRAY of: MAC address of physical interface
6 USINT
STRUCT of: InOctets, InUcastPackets, InNUcast-
Packets, InDiscards, InErrors, InUnk-
UDINT MibIICoun-
nownProtos, OutOctets,
ter1
OutUcastPackets, OutNUcastPa-
UDINT MibIICoun-
ckets, OutDiscards, OutErrors
ter2
...
STRUCT of: Erkannte Fehler:
Alignment, FCS, single collision,
UDINT Ether-
multiple collision, SQE Test, deferred
netMib Counter1
transmissions, late collisions, exces-
UDINT Ether-
sive collisions, MAC TX, carrier sense,
netMib Counter2
frame too long, MAC RX
...
WORD ControlBits 0:
1:
UINT ForcedInter- Interface speed in Mbit/s: 10,100,...,
face Speed if Auto-negotiation disabled
USINT Type of interface:
0: Unknown interface type
1: The interface is internal
2: Twisted-pair
3: Optical fiber
USINT Current state of the interface:
0: Unknown interface state
1: The interface is enabled
2: The interface is disabled
3: The interface is testing
Administrative state:
1: Enable the interface
2: Disable the interface
SHORT-STRING Human readable ID
Industrieprotokolle
17.2 Funktion EtherNet/IP
Link State (0=No link, 1=Link)
Duplex mode (0=Half, 1=Full)
Auto-negotiation Status
0x0=Auto-negotiation in progress
0x1=Auto-negotiation failed
0x2=Failed but speed detected
0x3=Auto-negotiation success
0x4=No Auto-negotiation
Manual configuration require reset
(constantly 0 because it is not
needed)
Hardware error
Control Bits:
Auto-negotiation enable/disable
(0=disable, 1=enable)
Duplex mode (0=Half, 1=Full),
if Auto-negotiation disabled
451