cecotec POWER ESPRESSO 20 SQUARE PRO Bedienungsanleitung Seite 41

Note: it is important to perform periodic descaling every two months to reduce incidences
caused by the accumulation of mineral debris in the ducts.
Coffee quantity programming
The operating time of each coffee can be changed and saved for future coffees with the
following process:
1. Place a cup in the water outlet in front of the machine.
2. With the selector on the coffee and the 3 lights on the control panel lit, press and hold the
single or double coffee button depending on which you want to change and the machine
will start to operate. The machine starts preparing coffee. When the desired infusion
time has elapsed, release the button. The time is saved for future coffees. The adjustable
minimum and maximum times are 10 to 90 seconds in both coffee modes.
Resetting to factory settings
Press and hold the double cup button, plug in the power supply and power button and the
double coffee button and the control panel will flash twice to indicate that it is resetting to
factory settings.
Procedure after shutdown due to lack of water in the tank
Situation 1: In the coffee brewing process, due to the lack of water in the water tank and the
addition of water again, air enters the internal water path, causing no water to come out in
the coffee brewing process.
Process to continue:
Turn the selector to the icon
under the steam pipe.
Situation 2: When the new machine is used for the first time, or is not used for a long time, the
internal drying of the water pump causes the machine not to discharge water.
Process to continue:
- Turn the rotating key until
- Insert the air pump into the water inlet hole of the water tank, then add the appropriate
amount of water. (Fig. 3).
- Pump water into the machine with the water pump. (Fig. 4)
, make sure you have filled the water tank and placed a cup
POWER ESPRESSO 20 SQUARE PRO
ENGLISH
41