cecotec POWER ESPRESSO 20 SQUARE PRO Bedienungsanleitung Seite 39

preheating.
- Take the portafilter and insert the single or double coffee filter according to your choice.
When fitting the filter, please note that the filter has a small outlet which must fit into the
filter holder recess.
- Insert the ground coffee into the filter with the help of the spoon/presser, then press the
coffee into the filter with the back of the spoon without letting it exceed the MAX line;
otherwise the filter holder will not be able to close properly.
- Position the portafilter in line with the "Unlock" position (Fig. 2) shown on the coffee
diffuser and turn the portafilter clockwise to the "Lock" position (Fig. 2) .
- Place the cup on top of the waste-water tray (make sure that there is more than 150 ml
of pure water in the water tank so that the coffee is not interrupted in the middle of the
process).
- Press the button for the desired amount of coffee (single or double) until brewing is
complete.
- When the button is pressed, the light in the button flashes while the coffee is being made.
At the end of the process the light will flash twice.
Note: please note that it will take a few seconds for coffee to brew due to preheating.
Milk preparation (Steam)
- Pour at least 50 ml of cold whole milk into the cup.
- Place the cup of milk in the steam pipe, making sure that the steam pipe is submerged in
the milk.
- Turn the selector towards the steam icon
flashes rapidly and the machine enters steam mode. At the beginning, it will be necessary
to wait for some time for the machine to warm up. This is normal. After heating, the
steam will automatically expel the frothy milk.
Note: before releasing steam, the device usually releases a little water, this is completely
normal because it is the residual water in the duct.
- After finishing this process, turn the selector until the coffee icon
process.
Note: after 120 seconds of continuous steam blowing, if the rotary knob does not return to
the coffee position, it will automatically stop blowing steam. It is necessary to turn the rotor
back to the coffee position and then turn it to the steam position so that steam is released
again.
Reminder: as the machine has just finished steaming, the heating body inside the machine is
at high temperature to ensure the effect and taste of coffee, please, do not start the coffee
mode immediately to brew coffee. If you wish to use hot water after using steam at the
beginning of the process, some steam may be expelled.
Note: it is very important to clean the vaporiser after each use, by generating steam again in
a glass of water. Then, very carefully due to the high temperature, remove the protector from
the vaporiser and clean with a damp cloth the internal duct through which the steam comes
, at this point, the steam indicator light
POWER ESPRESSO 20 SQUARE PRO
ENGLISH
, to pause the
39