Charging The Battery Packs - stabo freecomm 400 II Bedienungsanleitung

Provisions for the operation
Attaching/taking-off belt clip
Place the grooves of the belt clip on
the guide rails on the upper part of the
housing and slide the belt clip down-
wards until the safety catch snaps in.
For removing push the safety catch on
top of the belt clip away from the
housing and slide the belt clip upwards.

Charging the battery packs

The Li-Ion battery packs are precharged: Before using the devices,
the Li-Ion battery packs must first be fully charged (charging time ca.
3,5 hours).
Important note: the Li-Ion battery packs are already inserted at the
factory.
Charging the battery packs in the charger
Switch off the radio sets!
Plug the power supply unit into a
socket (230 V) and connect it to the
charger.
Place the radio sets into the two
charging shafts.
Both control lamps on the charger
emit yellow light, the battery packs
are now being charged.
If the control lamps light up green
the battery packs are fully charged.
Remove the devices.
24