stabo freecomm 400 II Bedienungsanleitung Seite 25

Safety instructions for the charger
Only use the charger in closed rooms. Protect it from humidity, dust,
heat and strong vibrations. The charger should be used only at tempe-
ratures between 5° and 40° C (charging outside the recommended
temperature range may result in battery packs which are not fully
charged).
The double tabletop charger must only be used for the charging of the
Li-Ion battery packs that are included in the scope of delivery! The
charger must only be operated with the delivered power supply unit.
Do not abuse it as DC voltage source for other applications.
Do not disassemble neither the power supply unit nor the charger.
Prevent small metal parts from penetrating into the charger.
Make sure that the radio sets are switched off during charging.
Do not charge the radio set if it has become wet! Only place the radio
set into the charger, if it is completely dry.
Disconnect the device from the mains if you do not use it.
Never short-out the contacts of the battery packs. Never throw the
battery packs into the fire.
packs
Insert battery
Push the latch up and remove the battery cover.
Insert the plug of the battery pack into the socket in the battery
compartment.
Insert the battery pack, being careful not to pinch the cable.
Slide the battery cover onto the housing and press down until the
latch snaps into place.
Information on disposal of battery packs
Used up battery packs are not to be thrown into the domestic waste.
Be sure to observe the national disposal regulations and dispose used
up battery packs (inserted into a small plastic bag) with the correspon-
ding collecting points.
25