Installation In The Car; Connecting The Antenna - stabo xm 3006e VOX 12/24 Bedienungsanleitung

Installation

Installation in the car

a) Preferably install the radio unit with the patented stabo slide-in holder (optional accessory)
into the DIN slot of the vehicle. Adhere to the instructions provided by your motor vehicle
manufacturer.
b) Make sure that all cables and connection lines are routed through the vehicle without any
problems. Do not route cables in the vicinity of the heater!
c) Fasten the mounting bracket (1) (see fig.) in a suitable position using the self-taping
screws (2) (diameter of the drilled hole: 3.2 mm). Make sure beforehand that the fastening
will not damage any lines inside the car! The mounting bracket should be fitted in a suitable
position which allows the radio device to be fastened firmly and securely with as little vibration
as possible.
d) Select a place for the microphone mount in which the microphone is close to hand at all
times and does not get in the way of its connection cable to the radio device.
Note: If there is so little space available for installation of the radio device that the sound
emitted from the speaker (on the base of the radio device) is obstructed, you should install
an external mobile speaker, as available in the stabo range of accessories. It is connected
to the EXT.SP socket (C) at the rear of the radio device, shutting off the internal speaker
automatically in the process.

Connecting the antenna

Selecting the antenna:
In CB radio the following applies: the better the antenna the greater the range of the station.
Make your choice based on the following recommendations.
Mobile antenna:
Tuned and tunable antennas are available.
Tuned antennas should only be mounted on a large metal surface, for example on the car roof
or on the boot lid.
In the process, make sure that there is a short connection to ground.
If you drill a hole in the bodywork for the antenna, the sheet metal must be sanded down flat to
do so in order for the fastening screw and the seal to rest properly in place.
Route the coaxial cable so that it is not kinked and does not rest on sharp edges (otherwise:
risk of short circuit!)
Fasten the antenna cable to the connection (B).
Fixed station antenna:
With a fixed station antenna you achieve the maximum range for your radio device. For
outdoor antennas it is imperative that you adhere to the valid VDE regulations (lightning
protection!), structural analysis and building legislation! Ideally, in this case you should have
the antenna system installed by a specialist.
The stabo range of accessories includes the ideal fixed station antenna.
Noir/czarny
Black/Schwarz
Rouge/czerwony
Red/Rot
18