stabo freecomm 400 II Bedienungsanleitung Seite 26

Battery save mode/battery low warning
The power consumption of this radio set is very small. If no signal is
received, the electronic battery stand-by mode is automatically activated
and appears on the display.
If the capacity of the battery pack is low,
display and the battery symbol
pack.
Functions
Note: If a setting is not activated within 10 seconds the radio set will
automatically adopt the last setting.
Switching on/off the radio set
Use the key to switch the radio sets on/off. Switching on is accom-
panied by a beep sound, the channel number is indicated and the
display lighting is activated for approx. 10 sec.
Switching off is accompanied again by a beep tone.
Adjusting the volume
Eight volume levels are available.
Press the VOL-/-key to adjust the volume: LE and the selected
volume level are indicated.
Through a long keystroke-/-key the volume is switched
continuously. Reaching the lowest/highest level is accompanied by a
beep tone.
Selecting the channel
Sixteen channels are available.
Press the CH-/-key and select a free channel. Through a long
keystroke the channels are switched continuously.
Note: Always adjust both radio sets to the same channel!
appears flashing on the
. Now you have to charge the battery
26