Ryobi RY36LMM46A-140 Bedienungsanleitung Seite 6

■ Turn off the product, and remove the isolator key and the
battery pack. Make sure that all moving parts have come
to a complete stop before any cleaning or maintenance
task.
■ Check all nuts, bolts, and screws at frequent intervals
for proper tightness to ensure that the product is in safe
working condition.
■ After each use, clean the plastic parts with a soft, dry
cloth. Any part that is damaged should be properly
repaired or replaced by an authorised service centre.
■ Replace damaged blades and bolts in sets to preserve
balance.
■ Be careful during adjustment of the product to prevent
entrapment of the fingers between moving blades and
fixed parts of the product.
■ The blade on the product is sharp. Use extreme caution,
and wear heavy-duty gloves when fitting, replacing,
cleaning, or checking bolt security.
■ The blade bolts must be adequately tightened. See the
manufacturer's recommendations for blade bolt torque,
which can be found in the product specification table in
this manual.
■ Be aware that even though the power source is turned
off, the blades can still be moved.
CLEARING BLOCKAGES
■ Turn off the product, and remove the isolator key and the
battery pack. Make sure that all moving parts have come
to a complete stop.
■ Always wear heavy-duty gloves when checking or
clearing a blockage. The blades are sharp, and the
blockage itself could be a sharp object.
■ Check the grass discharge chute, and carefully clear
blockages.
■ Turn the product on its side. Check its underside and the
area around the blade. Carefully remove any blockages.
Remember that the blade may move during cleaning.
KNOW YOUR PRODUCT
See page 125.
1. Start button
2. On/off lever
3. Handle
4. Motor control cable
5. Handle knob
6. Motor control cable retainer
7. Cutting height adjustment lever
8. Battery door
9. Side discharge chute
10. Door
11. Rear wheel
12. Front wheel
13. Isolator key
14. Operator's manual
15. Battery pack
16. Charger
SYMBOLS ON THE PRODUCT
Safety alert
6
Original Instructions
Read and understand all instructions
before operating the product. Follow all
warnings and safety instructions.
Wear ear protection.
Wear eye protection.
Do not operate the product on inclines
greater than 15°. Mow across the face of
slopes, never up and down.
Do not expose the product to rain or
damp condition.
Beware of sharp blades. Blades continue
to rotate after the motor is switched
off . Remove the isolator key before
maintenance.
Beware of thrown or fl ying objects.
Keep all bystanders, especially children
and pets, at least 15 m away from the
operating area.
Press the start button, and squeeze the
on/off lever to start the product. Release
the start button and keep squeezing the
on/off lever to run the product. Release
the on/off lever to stop the product.
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authority or retailer
for recycling advice.
European Conformity Mark
British Conformity Mark
EurAsian Conformity Mark
Ukraine Conformity Mark
Guaranteed sound power level
SYMBOLS IN THIS MANUAL
Parts or accessories sold separately
Note
Warning