Parker PVD 3405D Betriebsanleitung Seite 10

RS
2.2.2 Electrical features
The main features are indicated on identification plates.
The features are described in full in the commercial documentation.
2.3 Instructions for commissioning and use
2.3.1 Equipment delivery
All servomotors undergo a thorough quality control procedure before dispatch :.
•
Check the condition of the servomotor by carefully removing it from its packaging ;
•
Check that the information on the identification plate corresponds to your order. Check
also the accessories included in the box.
If the equipment has been damaged in transit, the recipient should immediately
complain to the carrier by registered letter within 24 hours.
2.3.2 Storage
Before installation, the servomotor should be stored in a dry place without large temperature variations
in order to prevent condensation.
If it is to be stored for a long time, check that the end of the shaft and the face of the flange are always
coated with an anti-corrosion product.
After lengthy storage (more than 3 months) rotate the motor at low speed
2.4 Installation
2.4.1 Preparation
The servomotor may be positioned anywhere but it must allow access to the brush holder and
identification plate. Air must be able to circulate freely around the motor for cooling. For optimum
service life, motors should be protected from liquids and dust.
The cable outlets should be at the bottom in order to prevent dust or liquid deposition in the cable
glands.
Clean the drive shaft using a cloth soaked in white spirit, alcohol or acetone, ensuring that no liquid
enters the bearings. The servomotor should be in a horizontal position during cleaning.
2.4.2 Mechanical installation
The service life of the servomotor bearings depends largely on the care exercised during this
operation.
•
Ensure that the coupling devices are well balanced without a key, as the servomotor has
been balanced with the whole key (in the case of servomotors with a key).
•
Check carefully the drive shaft alignment with that of the driven machine in order to
prevent vibration, irregular movement or too high loads on the shaft.
•
Avoid any impact on the shaft which could mark the bearing, mountings or machining on
the shaft (holes, milling, etc).
•
If the motor is driven by a timing belt, the drive pulley should be located as close as
possible to the flange. The pulley diameter should be such that the radial force does not
exceed the limits given in the catalogue.
10
PVD 3405 - 01/2023