Scheppach WDT30 Originalbetriebsanleitung Seite 24

16. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Motor does not run
Reduced vacuuming
power
24 | GB
Possible cause
Check whether the plug is
plugged in.
Check whether there is
power to the socket.
Check whether the vacuum
cleaner on/off switch is
switched on.
Is the brush blocked?
Is the dust bag full of dust?
Is the filter full of dust?
www.scheppach.com
Remedy
Plug the mains plug back in to the socket.
Call an electrician.
Switch the on/off switch on.
Switch the vacuum cleaner off to remove the blockages.
Remove and empty the dust bag.
Remove and empty the filter.