2. Mounting and Installation
Installation must be performed by authorized and skilled electricians only.
Before mounting and installation, pull the mains plug!
The DVB-C/T/T2 distribution network must be installed and connected to the equipotential bonding according to EN 60728-
11.
Install the device in compliance with the safety regulations defined by the EN 60728-11 standard.
2.1.
Mounting
Note: There must be at least 5 cm clearance in front of and behind the unit.
Slide the device into a 19 "rack.
Screw the device with four screws (2).
Install the device in compliance with the safety regulations defined by the EN 60728-11 standard.
2023-06-15 | Technical improvements, changes in design, printing- and other errors reserved. | BA_MIE-N.pdf |
Page 11 of 70