Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operation instructions | MIE 8-00N | MIE 16-00N | MIE 32-00N | MIE 4-02N | MIE 8-02N | MIE 3-02N | MIE 6-02N
A table lists the devices that are in the same subnet (in the example 192.168.0.xxx)
Select the device to be monitored.
If the device is on a different subnet, enter its IP address manually and click READ NAME.
Under CONDITIONS TO REPLACE THE DEVICE, select the conditions under which to switch to the backup device:
•
Input failure: The input data rate at IPTV IN1 and IPTV IN2 is below the configured minimum input data rate.
•
Output failure: The output data rate (sum of the data rates of all active modulators) is below the configured minimum
output data rate.
RF level to low: The measured output level is too low compared to the user-configured output level (initialization → Phase 3
•
→ Common output level)
•
Power failure: The internal voltage is too low (< 11.0 V).
•
Temp to high: The temperature of the processor rises too high (> 90° C). At this temperature, the unit will still operate
normally, but probably there are ventilation problems, and the temperature will continue to rise. Selecting this condition
allows an immediate smooth transition before the temperature rises so high that the processor may stop working.
•
No connection (>120s): The backup device is not able to connect to the monitored device via the Control port within 120 s.
Note: This option requires special caution! For example, a loose Ethernet cable can separate the two devices, which can
lead to an unwanted replacement, and both devices send HF output signals simultaneously.
Switching to the backup device is normally done after the device has been in an error state for more than 60 seconds
(exception for the No connection error (> 120s)).
Select one or more conditions.
Then click SAVE CHANGES.
Page 62 of 70
BA_MIE-N.pdf | Technical improvements, changes in design, printing- and other errors reserved. | 2023-06-15
Werbung
