Operation instructions | MIE 8-00N | MIE 16-00N | MIE 32-00N | MIE 4-02N | MIE 8-02N | MIE 3-02N | MIE 6-02N
3.4.8.
OTA upgrade
To enable an Over-the-Air upgrade, two functions are available in the configuration:
•
Non-referenced PIDs can be manually added to the output modulators
•
Custom descriptors can be added to the NIT
Both are located in PHASE 2 under ADVANCED OPTIONS.
Note: The function requires a valid license for "PID-Filtering" (see 3.8 on page 53).
Add non-referenced PIDs
Requirement: In PHASE 1 a transport stream must already be selected which contains the unreferenced PID/PIDs.
Click in PHASE 2 on ADVANCED OPTIONS.
A dialog with options will open.
Under Add unreferenced PIDs, click the green plus sign in the table header.
A line for entering the PID is inserted.
Under Input, select one of the available input streams.
Under In PID, enter an unreferenced PID.
Select the output Modulator.
Under Out PID, enter the output PID. The output PID can be the same or different from the input PID.
Click on the green plus sign next to the line.
The entered data are inserted.
If necessary, enter additional non-referenced PIDs.
Page 32 of 70
BA_MIE-N.pdf | Technical improvements, changes in design, printing- and other errors reserved. | 2023-06-15