Replacing The Fuse; Technical Specifications - EuroLite LED MS-1 Bedienungsanleitung

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.

8. TECHNICAL SPECIFICATIONS

Power supply:
Power consumption:
LED power:
Laser classification:
Wavelength:
Laser-modules:
Beam angle:
Dimensions (LxWxH):
Weight:
Fuse:
Please note: Every information is subject to change without prior notice. 07.04.2011 ©
100-240 V AC, 50/60 Hz ~
35 W
5 W, 455 nm, blue
3B
650/532 nm
Red 80 mW, green 30 mW
approx. 30°
180 x 240 x 165 mm
1.5 kg
F 1 A, 250 V
26/26 00051281.DOC, Version 1.1