Stand Alone-Mode; Dmx Mode - EuroLite LED PFE-120 3000K Profile Spot Bedienungsanleitung

STAND ALONE-MODE

In the Stand Alone mode, the LED PFE-120 3000K Profile Spot can be used without controller.
Disconnect the LED PFE-120 3000K Profile Spot from the controller.
Dimmer
Press the MODE button until the display shows "Dimmer". Press ENTER to confirm.
You can now select the desired brightness via the UP or DOWN buttons.
Value:
000 – 4096
Press ENTER once again to confirm. Press the MODE button in order to return to the main menu.
Strobe
Press the MODE button until the display shows "Strobe. Press ENTER to confirm
Via the UP or DOWN buttons, you can set the desired strobe speed. You can choose from 13 speeds, with
increasing rate.
Value:
00 ~ 12
Press ENTER once again to confirm. Press the MODE button in order to return to the main menu.
Master/Slave
Set the Master device to Dimmer or Strobe mode and set each Slave device to the same DMX address
"001".
Focus
Step 1: Loosen the focus fixation screws on both sides of the device.
Step 2: Adjust the focus by sliding the lens-housing forward or backward.
Step 3: Tighten the focus fixation screws on both sides of the device.
Zoom
Step 1: Loosen the zoom fixation screws on both sides of the device.
Step 2: Adjust the zoom by sliding the lens-housing forward or backward.
Step 3: Tighten the zoom fixation screws on both sides of the device.
Please note: When setting the focus or zoom, always adjust on both sides of the unit. One-sided adjusting
could lead to a misalignment in the guide grooves.

DMX MODE

You can control the devices individually via your DMX-controller.
Addressing
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the device will respond to the controller.
Press the MODE button until the display shows „DMX512". Press ENTER to confirm.
You can now set the desired address via the UP or DOWN buttons. Press ENTER once again to confirm.
Press the MODE button in order to return to the main menu.
Please, be sure that you don't have any overlapping channels in order to control each device correctly and
independently from any other fixture on the DMX-chain.
If several devices are addressed similarly, they will work synchronically.
Function:
0 – 100 % increasing brightness
Function:
Speed 0 ~ Speed 12
21/23 00094464.DOC, Version 1.1