TOOLCRAFT ZD-8908 Bedienungsanleitung Seite 21

• The product must only be set up, used or stored in places that are not accessible to children. Children
must be supervised to ensure that they do not play with the device. Danger of burns!
• Avoid setup in direct proximity of strong magnetic or electromagnetic fields, transmitter aerials or HF
generators. This can affect the control electronics.
• Ensure that the cables are not crushed or damaged by sharp edges. Never place any objects on the
cables.
• Do not place any containers filled with liquid, vases or plants, on or next to the hot air soldering/unsolder-
ing system or the mains cable.
When these liquids get into the hot air soldering/unsoldering system, the hot air soldering/unsoldering
system will be destroyed and there is the highest danger of potentially fatal electric shock or fire.
If liquid has entered the hot air soldering/unsoldering system, first switch off the mains voltage for the
mains socket to which the hot air soldering/unsoldering system is connected (switch off the correspond-
ing circuit breaker or take out the fuse, then switch off the fault interrupter protection switch (FI circuit
breaker) so that the mains socket is separated from the mains voltage on all poles). Only then unplug the
mains plug of the mains cable from the mains socket.
Do not use the product any more after this, but take it to a specialised workshop or dispose of it in an
environmentally compatible manner.
d) Operation
• Do not operate the hot air soldering/unsoldering system inside of rooms or in bad ambient conditions
where flammable gases, vapours or explosive dust may be or are present! There is a danger of explo-
sion!
• Do not attach any objects to the hot air soldering/unsoldering system. Never cover the hot air soldering/
unsoldering system. There is a danger of fire!
• When one of the enclosed nozzles is attached to the tip of the hot-air nozzle, observe that it is correctly/
completely pushed on and cannot come loose.
• The hot air soldering/unsoldering system is only intended for operation on mains voltage (230 V/AC,
50 Hz). Connect the hot air soldering/unsoldering system only to a proper mains socket of the public
mains via the mains cable.
• Never use the hot-air soldering/desoldering system to heat up liquids or gases.
• Never perform soldering work on live components or elements. Switch off the voltages first.
Caution!
Touching or soldering capacitors (or similar components) or connected lines/conductors may cause po-
tentially fatal electric shock! Capacitors may be charged even hours after the operating voltage was
switched off!
• Depending on workpiece or soldering process, the workpiece must be fastened with suitable clamps.
This will leave both of your hands free for soldering.
21