Danger To Life - Elektro-Automatik PS 8000 DT Bedienungsanleitung

General
About
Elektro-Automatik GmbH & Co. KG
Helmholtzstrasse 31-33
41747 Viersen
Germany
Phone: +49 2162 / 37850
Fax: +49 2162 / 16230
Web: www.elektroautomatik.de
Mail: ea1974@elektroautomatik.de
© Elektro-Automatik
Reprint, duplication or partly, wrong use of this user instruction
manual are prohibited and might be followed by legal conse-
quences.
Instruction Manual
PS 8000 DT Series

Danger to life!

Hazardous voltage
The output voltage of some models can rise up to hazar-
dous levels of >60V !
DC
All live parts have to be covered. All actions at the out-
put terminals have to be done while the unit is switched
off from the mains (mains switch OFF) and may only be
executed by personnel which is instructed about the
hazards of electrical current. Any connection between
the load and the unit (at the output terminals) have to be
scoop-proof. Applications connected to the power output
must be configured and fused in a way that prevents the
use of these to cause a damage or worse to the unit by
overload or malfunction.
Caution!
The DC output can still have hazardous voltage for a
certain time after the output or the device has been
switched off!
Keep in mind:
• Only operate the device at a mains voltage as stipulated
on the type plate
• Never insert mechanical parts, especially from metal,
through the air ventilation slots
• Avoid any use of liquids of any kind in the proximity of the
device, they might get into it
• Do not connect voltage sources to the device which are
able to generate voltages higher than the nominal voltage
of the device
• In order to equip interface cards into the slot at the rear, the
common ESD provisions have to be followed
• The interface card may only be plugged and unplugged
while the unit is completely switched off (mains switch OFF)
• Aging of the device, as well heavy use may result in un-
predictable behaviour of control elements like pushbuttons
and rotary knobs.
• Do not connect external voltage sources with reversed
polarity to the DC output! The device will be damaged.
• Avoid connecting external voltage sources to the DC output,
especially those who can generate voltages higher than
specified for the device!
Date: 12-03-2012
EN
25