Daily Use; Setting And Starting A Programme - AEG GS55AIW Benutzerinformation

12 www.aeg.com

9. DAILY USE

1. Open the water tap.
2. Press the on/off button to activate
the appliance.
Make sure that the appliance is in user
mode.
• If the salt indicator is on, fill the
salt container.
• If the rinse aid indicator is on, fill
the rinse aid dispenser.
3. Load the baskets.
4. Add the detergent.
5. Set and start the correct programme
for the type of load and the degree
of soil.
9.1 Using the detergent
A
CAUTION!
Only use detergent
specifically designed for
dishwashers.
1. Press the release button (B) to open
the lid (C).
2. Put the detergent, in powder or
tablets, in the compartment (A).
3. If the programme has a prewash
phase, put a small quantity of
detergent on the inner part of the
appliance door.
4. Close the lid. Make sure that the
release button locks into position.
9.2 Setting and starting a
programme
The AUTO OFF function
This function decreases energy
consumption by deactivating
B
30
20
C
automatically the appliance when it is not
operating.
The function comes into operation:
• 5 minutes after the completion of the
programme.
• After 5 minutes if the programme has
not started.
Starting a programme
1. Keep the appliance door ajar.
2. Press the on/off button to activate
the appliance. Make sure that the
appliance is in programme selection
mode.
3. Press again and again until the
indicator of the programme you want
to select comes on.
• If you want to select the
MyFavourite programme, press
MyFavourite.
The programme indicator of the selected
programme flashes.
The display shows the programme
duration.
4. Set the applicable options.
5. Close the appliance door to start the
programme.
• The programme indicator stops
flashing and comes on with fixed
light.
• The programme duration starts to
decrease with steps of 1 minute.
Starting a programme with
delay start
1. Set a programme.
2. Press Delay again and again until the
display shows the delay time you
want to set (from 1 to 24 hours).
The delay time flashes in the display.
3. Close the appliance door to start the
countdown.
The delay time stops flashing and comes
on with fixed light.
• When the countdown is completed,
the programme starts.
• While the countdown is running only
the buttons Reset and Delay are
active. It is not possible to change the
programme or options.