Krups ESPRESSERIA AUTOMATIC EA82FB10 Bedienungsanleitung Seite 20

PROBLEMS
The coffee flows too slowly.
The coffee is not creamy enough.
The appliance does not serve any
coffee.
Why can I not run descaling/why
does my machine not request a
descaling cycle?
You have used ground coffee
instead of bean coffee.
The grinder makes a strange noise.
The grinding fineness knob is hard
to turn.
The steam does not come out of
the nozzle.
There is not enough milk froth.
The milk froth is too bubbly.
The Auto-Cappuccino accessory
does not suck the milk (accessory
sold separately).
After emptying the used coffee
collector, the warning message is
still displayed.
The power has been cut off during a
cycle.
There is water or coffee underneath
the appliance.
A message appears.
18
CORRECTIVE ACTIONS
Turn the grinding fineness knob towards the right for a coarser grind (may depend
on the type of coffee used).
Carry out one or two rinsing cycles.
Turn the grinding fineness knob towards the left for a finer grind (may depend on
the type of coffee used).
Change the Claris Aqua Filter System cartridge (follow the installation procedure
on page 13).
Carry out one or two rinsing cycles.
An incident has been detected during the preparation. The appliance resets itself
automatically and is then ready for a new cycle.
The machine only requests a descaling cycle once it has made a certain number
of drinks using steam.
Use your vacuum cleaner to suck out the pre-ground coffee in the coffee bean
tank.
There are foreign particles in the grinder.
Contact KRUPS' Customer Service.
Only change the grinder setting when it is operating.
After switching off your appliance and leaving it to cool:
Make sure the tip of the steam nozzle is properly affixed. Make sure the steam
nozzle is not clogged at the aerator (if necessary clean the steam nozzle aerator
with the needle supplied). Empty the tank and remove the Claris filter. Fill the tank
with mineral water high in calcium (> 100 mg/litre or .015oz/gallon), it may take as
many as 5 to 10 cycles of steam at 60 seconds each cycle to achieve a continuous
jet of steam.
Using the needle supplied unblock the small air inlet at the top of the nozzle if
required.
Use a cold container and milk that has been opened recently.
Try changing the type of milk if this does not work (UHT or pasteurised).
Check that the two ends of the small stainless steel tube are fitted correctly into
the flexible part of the steam nozzle.
Ensure that the tube immersed in the milk is not blocked.
Check that the flexible tube is not twisted and that it is correctly fitted into the
accessory to avoid any air being sucked in.
After switching of your appliance and leaving it to cool, unblock the outlet of the
Auto-Cappuccino accessory.
Remove the collector, ensure that it is empty, wait for 6 seconds and fit it back in
place.
Check that the collector is pushed in correctly.
The appliance resets itself automatically when the power is switched back on and
is ready for a new cycle.
The drip tray has overflowed: empty it and clean the cleaning drawer.
Check that the drip tray is fitted correctly.
Do not remove the water tank before the end of the cycle.
Unplug the appliance for 20 seconds, remove the Claris cartridge and if required,
put it back into service.
If the fault persists, note the fault number and contact KRUPS' Customer Service.