Preparing Hot Water - Krups ESPRESSERIA AUTOMATIC EA82FB10 Bedienungsanleitung

Rinsing out the steam circuit :
Place a container under the steam nozzle. Press the
automatically after the volume of water displayed has flowed through.
Press at any time to display menus to perform rinsing and then select MAINTENANCE => OK => RINSING.
It is best to perform rinsing after the appliance has remained unused for several days.
WHEN RINSING PROCESS IS IN PROGRESS, HOT WATER COMES OUT THROUGH THE NOZZLES. BE CAREFULL
NOT TO BE SCALDED.
Preparing the grinder
Adjust the fineness of your coffee grinding to set the strength of your coffee. The finer the grind setting, the stronger and
creamier the coffee will be.
Turn the "Grinding fineness setting" button to set the degree of grinding fineness.
Turn anticlockwise for a finer grind. Turn clockwise for a coarser grind. - Fig. 15.
CHANGE THE SETTING DURING GRINDING.
NEVER FORCE THE GRINDING FINENESS SETTING BUTTON.
PREPARING ESPRESSO AND ORDINARY COFFEE
YOUR APPLIANCE IS DESIGNED TO MAKE COFFEE FROM COFFEE BEANS ONLY.
When you first make coffee with the machine or after a long period of absence or a cleaning or scale removal
procedure, a little steam and hot water will come out of the steam nozzle (priming).
Splashing or scalding may occur if the coffee outlets are set too high in relation to the size of the cups.
Preparing an espresso
The quantity of water for an espresso must be between 20 and 70 ml.
Press the button, wait for the end of pre-heating and perform a rinsing operation if you wish.
Each time you plug your machine in, it will carry out an initialisation cycle.
The drink selection menu will be displayed - Fig. 16.
Put a cup under the coffee outlets. You can lower or raise the coffee outlets to suit the size of your cups - Fig. 17.
Use the rotating button to select your drink - Fig. 12 and confirm by pressing the OK key - Fig. 13.
You can change the volume of water at any time using the rotating button - Fig. 12.
To stop coffee flowing into the cup, you can either again press a key or turn the rotating button to reduce
volume.
Making a coffee
The amount of water required for a coffee is between 80 and 160 ml.
Making a long coffee
The amount of water required for a long coffee is between 120 and 240 ml. The machine automatically carries out a double
cycle, do not remove your cup before the process has ended.
The ground coffee is first moistened using a little hot water after the grinding stage. A few moments later, percolation
as such begins.
There is a temperature setting function to control how hot your coffee is.
DO NOT REMOVE THE WATER COMPARTMENT BEFORE THE END OF THE CYCLE (that is around 15 seconds
after the coffee has finished dripping through).
2-cup function
Your appliance enables you to prepare 2 cups of coffee or espresso for the following 3 kinds of drink : espresso / strong
espresso / coffee. For "Large coffee" drinks, the 2-cup function is not available. Remember not to remove the cups after
the first cycle. You have now prepared your appliance. The drink select menu will be displayed.
Put two cups under the coffee outlets. You can lower or raise the coffee outlets to suit the size of your cups.- Fig. 17.
Select your drink and confirm by clicking twice on the OK key.
A message will appear to tell you that you have chosen two cups.
The appliance will automatically sequence 2 complete coffee-making cycles.
While the screen displays the drink selection menu, press the "hot water" key
A message will invite you to place a container under the steam nozzle. Again press the "hot water" key
water - Fig. 14.
key to rinse the steam circuit - Fig. 14. The rinsing cycle will stop

PREPARING HOT WATER

.
to produce hot
13