Preparing Steam; Frothing Milk; Maintaining Your Appliance - Krups ESPRESSERIA AUTOMATIC EA82FB10 Bedienungsanleitung

To interrupt the steam function, just press any key.
If the nozzle is blocked, clean it out with a fine needle.
The maximum amount of hot water per cycle is limited to 300 ml.
Steam froths up the milk to make a cappuccino or a caffe latte, for example, and also heats up liquids. As you need a
higher temperature to produce steam than to make an espresso, the appliance runs an additional pre-heating phase for
steam.
While the screen displays the drink selection menu, press the "steam" key
appliance is being pre-heated. Once the pre-heating phase has been
completed, a message will ask you to place a container under the steam nozzle - Fig. 5. Press the "steam" key
to start generating steam. A little water will be produced first and then steam will start. Use the same key to stop
steam generation.
BE CAREFUL, BECAUSE THE CYCLE DOES NOT STOP IMMEDIATELY.

Frothing milk

We recommend that you use pasteurised or UHT milk that has been recently opened. Do not use untreated milk. After
the steam function has been used, the nozzle will be hot, and we recommend that you wait for a few moments before
handling it.
Check that the steam nozzle is correctly fitted - Fig. 19.
Pour the milk into your milk jug. Only half fill it. Immerse the nozzle in the milk - Fig. 20.
Press the "steam" key
Once your milk is frothy enough... - Fig. 21, again press the "steam"
cycle does not stop immediately.
To remove any remaining milk from the steam nozzle, place a container under the nozzle and press the "steam" key
Let the hot water escape for at least 10 seconds and then again press the "steam" key
You can remove the steam nozzle for thorough cleaning. Wash it using a brush with water
and a little non-abrasive washing up liquid. Rinse and dry it - Fig. 22-23. Before re-fitting, make certain that the air inlet
holes are not clogged by milk residues. Clean out the holes with a needle if necessary - Fig. 24.
To interrupt the steam function, just press any key.
If the nozzle is blocked, clean it out with a fine needle.
The maximum duration for production of steam per cycle is limited to 2 minutes.
Setting up the Auto-cappuccino XS 6000 (sold separately)
This auto-cappuccino accessory makes it easier to make a cappuccino or a caffe latte.
Attach the various parts together. - Fig. 25.
Select the cappuccino or caffe latte position on the special nozzle - Fig. 26.
Fill up the milk pot - Fig. 27 and place a cup or a glass underneath the auto-cappuccino nozzle - Fig. 28.
Press the button to start and then to stop the cycle.
Place your cup under the coffee outlets and start a coffee / espresso cycle - Fig. 29.
The tube must not be twisted to ensure that the button is held in the correct position.
To prevent milk from drying on the auto-cappuccino accessory, it must be cleaned thoroughly after use.. It is
recommend that you wash it immediately by carrying out a cycle with steam and the accessory pot filled with water
in order to clean the inside of the nozzle. To do so, you can use liquid cleaner XS4000, available as an accessory.
Caution! To benefit from the guarantee conditions, it is essential to perform the appliance cleaning or a scale
removal cycle when informed to do so. Be sure to follow the order of operations. You can continue to use the
appliance, but you are advised to perform the program as soon as possible.
Emptying the coffee grounds collector, the coffee cleaning tray and the drip tray
If the above message appears- Fig. 30, remove, empty and clean the drip tray.
Remove, empty and clean the coffee grounds collector - Fig. 31.
Remove the coffee cleaning tray - Fig. 32.
The drip tray is equipped with floats to tell you when to empty it.- Fig. 33.
As soon as you remove the coffee grounds collector, you will have to empty it completely to avoid any overflow.
14

PREPARING STEAM

and follow the instructions on the screen.

MAINTAINING YOUR APPLIANCE

- Fig. 18. A screen will inform you that the
key to stop the cycle. Be careful, because the
to stop water.
again
.