Troubleshooting Guide - Kärcher T 1 T-Racer Surface Cleaner Bedienungsanleitung

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

● Recoil danger. Keep proper

footing and hold the high-pres-

sure gun and extension tube

firmly.

● Maximum water temperature

40°C (please observe the in-

structions for your high-pres-

sure cleaner).

Note

● Be sure to always adhere to

the safety instructions for your

high-pressure cleaner and the

locally applicable regulations

and directives.

Symbols on the device

DANGER

Risk of injury! Never reach under the

edge of the T-Racer during operation

Device description

For the illustrations, refer to the graphics page

Illustration A

Extension tube

Casing

Adapter with bayonet connector

Bristle crown (T2 only)

High-pressure nozzle

Rotor arm

Installation

Note

One-time installation. The adapter can no longer be re-

moved.

Illustration B

1. Fit the adapter into the opening in the housing.

2. Turn the adapter clockwise until it latches into place.

Extension tube installation

Note

Ensure that the device components are tightly connect-

ed on installation.

Illustration C

1. Plug the bayonet into the mounting.

2. Turn the extension until it latches into place.

Repeat the procedure for all further extension tubes.

Operation

Note

The extension tubes can be used with all Kärcher ac-

cessories.

Note

For optimum cleaning results, do not operate the high-

pressure cleaner in the Eco mode.

Remove coarse dirt from the surface to be cleaned (e.g.

by sweeping) before using the device to avoid damage

to the T-Racer.

ATTENTION

Damage to the rotor arm

The rotor arm can be damaged if it hits edges and cor-

ners.

Do not move the device over free-standing corners and

edges.

Illustration D

Note

 The T-Racer is not suitable for scraping or scrub-

bing.

 Test the device on an inconspicuous area before us-

ing on sensitive surfaces, e.g. wood.

 Do not allow it to remain in one area, but keep it in

motion.

1. Clean the floor surface by guiding the T-Racer over

the floor surface without exerting excessive pres-

sure.

Cleaning wall surfaces

1. Attach the T-Racer directly to the high-pressure gun.

a Press the bayonet connector of the T-Racer into

the connection on the high-pressure gun and

then turn by 90° until it latches into place.

b Tighten the union nut if present.

2. Clean the wall surface.

Rinse off the device with a gentle water stream after

use.

 Detach the T-Racer and any extension tubes from

the high-pressure gun.

 Rinse off the T-Racer with the high-pressure gun

(without accessories) or wipe down with a damp

cloth.

Store the device in a frost-protected place.

Care and service

Removing/installing the nozzles

The described procedure applies to all nozzles on the

device.

Illustration E

1. Remove the clip.

2. Pull the high-pressure nozzle out.

3. Fit the high-pressure nozzle.

4. Fit the clip.

Cleaning the high-pressure nozzle

1. Remove the high-pressure nozzle.

2. Flush the high-pressure nozzle with clear water in

both directions. Replace a damaged high-pressure

nozzle where necessary.

3. Install the high-pressure nozzle.