Dometic Midi Heki FL Montage- Und Bedienungsanleitung Seite 8

Installation
See fig. 7
A
NOTICE! Damage hazard
Observe the sealant manufacturer's instructions.
➤ Seal the mounting frame with a flexible non-hardening sealing compound (e.g.,
SikaLastomer-710).
See fig. 8
1. Check the direction of travel when installing.
The roof light can be fitted sideways (hinge-side at front in direction of travel) or
lengthwise (hinge-side on left or right in direction of travel).
2. Place the outer frame in the middle of the roof opening.
I
NOTE
Electric version: Pay attention to the power supply lines.
3. Press the outer frame in the roof slightly so that the sealing compound spreads
out.
See fig. 9
➤ Place the 11 mounting supports on the inside of the vehicle all the way into the
recess of the outer frame.
When using wooden rails as reinforcement
A
NOTICE! Damage hazard
Do not drill through the roof construction.
1. Pre-drill two 2.2 mm holes for each mounting support in the roof construction
(A).
2. Fix the mounting supports on the roof with the ∅ 3.5 mm screws included (B).
For other constructions, suitable screws must be used (not in scope of delivery).
3. Fix the 11 mounting supports with the ∅ 4 mm fixing screws (C).
To do this use the large holes in the mounting supports.
4. Tighten the screws and re-tight them 10 minutes after installation.
8
Midi Heki FL
EN