Motor Protection / Safety Device; Maintenance And Cleaning - IKA KS 130 basic Betriebsanleitung

PC 2.1 Cable
This cable is required to connect the 9-pin connector to a PC.
PC 1.2 Adaptor
This adaptor is required to connect the 9-pin connector to an 8-way
serial interface (25-pin plug).
AK 2.1 Cable
This cable is required to connect the 7-pin connector to a chart recor-
der (4mm pin plug).
AK 2.2 Cable
This cable is required to connect the 15-pin connector to a chart
recorder (4mm pin plug).

Motor protection / safety device

If the motor is locked or if a load is placed on it resulting in a higher
temperature than is permitted, the device is turned off automatically
by the safety circuit and the control light flashes. To eliminate the
error, the weight of the material must be reduced. Allow the device
to cool off.
The device must be turned off and backon again.
The motor is turned off immediately in the event of a malfunction by
a safety circuit. Amalfunction occurs if the safe and secure functiona-
lity of the device cannot be guaranteed. A malfunction is displayed
for the Basic model by the red Off signal light coming on and flas-
hing, and for the Control model by the error message being shown
on the display of the speed indicator (see the section "Error Codes".

Maintenance and cleaning

The KS 130 basic and KS 130 control are maintenace-free. It is subject
only to the natural wear and tear of components and their statistical
failure rate.
When ordering spare parts, please give the manufacturing
number shown on the type plate, the machine type and the
name of the spare part.
Please send in equipment for repair only after it has been cle-
aned and is free from any materials which may constitute a
health hazard. Use only cleansing agents which have been appro-
ved by IKA ® to clean IKA ® devices. To remove use:
Dyes isopropyl alcohol
Construction materials water containing tenside / iso
propyl alcohol
Cosmetics water containing tenside / iso
propyl alcohol
Foodstuffs water containing tenside
Fuels water containing tenside
- Do not allow moisture to get into the appliance when cleaning.
- Wear protective gloves when cleaning the devices.
- Please consult with IKA ® before using any cleaning or decon-
taminationmethods, other than those recommended here.
Before using another than the recommended method for cleaning
or decontamination, the user must ascertain with the manufacturer
that this method does not destroy the instrument.
Repair
Please send instrument in for repair only after it has been
cleaned and is free from any materials which may constitute
a health hazard.
For this you should request the "Decontamination Certificate"
from IKA ® , or use the download printout of it from the IKA
website www.ika.com.
Return the instrument in its original packaging. Storage packa-
ging is not sufficient. Also, please use suitable shipping package
materials.
®
33