Operating Instructions; Ce-Declaration Of Conformity; Safety Instructions - IKA ULTRA-TURRAX Tube Drive Betriebsanleitung

Contents
CE-Declaration of conformity
Safety instructions
Unpack
Correct use
Useful facts
Commissioning
Error message
Accessories
Maintenance
Warranty
Technical data

CE-Declaration of conformity

We declare under our sole responsibility that this product corre-
sponds to the regulations 73/23/CEE, 89/336/CEE and 98/37/CEE
and conforms with the standards or standardized documents DIN
EN IEC 61010-1; DIN EN IEC 61326-1; DIN EN ISO 12100-1, -2 and
EN 60204-1.

Safety instructions

For your protection
• Read the operating instructions in full before starting up and
follow the safety instructions.
• Follow the safety instructions, guidelines, occupational health
and safety and accident prevention regulations.
• Keep the operating instructions in a place where they can be
accessed by everyone.
• Ensure that only trained staff work with the appliance.
8
All manuals and user guides at all-guides.com
• The device must be supervised at all times when in operation.
EN
• The device must only be operated with a tube attached; with no
tube there is a risk of injury from the rotating locating pin.
Page
• Hearing protection must be worn when working with BMT-20 tubes.
• Wear your personal protective equipment in accordance with the
8
hazard category of the medium to be processed. Otherwise
8
there is a risk of:
9
- splashing liquids
9
- projectile parts
10
- body parts, hair, clothing and jewellery getting caught.
10
• Set up the appliance in a spacious area on an even, stable, clean,
11
non-slip, dry and fireproof surface.
11
• The feet of the appliance must be clean and undamaged.
11
• The appliance is not suitable for manual operation.
12
• The appliance may heat up when in use.
12
• Check the appliance and accessories beforehand for damage each
time you use them. Do not use damaged components.
• Ensure that the cover is screwed on tightly.
• Ensure that the tube is firmly attached to the bayonet lock
connector on the drive unit prior to operating the device.
• The tube must only be attached and removed whilst the motor is sta-
tionary.
• The IKA tubes must always be closed when the device is in ope-
ration. Switch off the device immediately if any material leaks
from the tube. Clean the equipment.
• Always open the tube carefully after use as the media in the tube
may heat up due to transfer of energy during operation, leading
to pressurization of the container: risk of material spraying, pro-
tective equipment must be worn.
• The temperature of the material must not exceed 40 °C.
• Only use tubes approved by IKA.
• Only process media that will not react dangerously to the extra
energy produced through processing. This also applies to any
extra energy produced in other ways, e.g. through light irradiation.
• Beware of the risk of flammable materials
• Do not operate the appliance in explosive atmospheres, with
hazardous substances or under water.
• The appliance starts not up again automatically following a cut in
032007