Omnitronic XDA-1204 Bedienungsanleitung Seite 15

XDA-1206
No. Element
1 Power switch
2 Power indicator
3 Level controls
4 SIG status indicator
5 CLIP status indicator
6 XLR input jacks CH 1-6 IN
7 Plug-in screw terminals IN
8 Terminals LINK OUT
9 Plug-in screw terminals CH 1-6 OUT
10 AC input with fuse holder
Function
Turns the amplifier on and off
Indicates that the amplifier is switched on
Independent level controls for each PA zone
Lights up when a specific signal level has been reached
Lights up in case of overload
Balanced inputs to connect signal sources with line level
Balanced inputs to connect signal sources with line level
Feed-through outputs for connection of a further amplifier
To connect speakers for each PA zone
Used to plug in the supplied power cord;
only replace the fuse when the device is disconnected from mains. Only
use fuses of the same rating and power. The correct fuse value is specified
on the rear panel.
15 • EN