Before Initial Use; Appliance Description; Trimming The Insoles To Size - Crivit CEB 2000 A1 Bedienungsanleitung

The recirculation of packaging into the material circuit
saves on raw material and reduces the amount of
waste generated. Dispose of packaging material that
is no longer needed as per the regionally established
regulations.

Before initial use

Remove all packaging materials and all transport securing devices
from the appliance.
NOTE
► With initial use and for a brief period, a light odour accumu-
lation can occur. This is normal and completely harmless.

Appliance description

Insole connector plug
Insole (underside)
Trimming marks
Connection socket of the battery pack
Function indicator of the battery pack
Function switch for the heat settings
Battery pack
Mains power connector for power pack
Connector plugs for power adapter

Trimming the insoles to size

IMPORTANT
The heating element is located in the region of the toes.
► Under no circumstances should you cut within the warning
symbol ,as this may damage the heating element.
♦ First, select the shoes in which you wish to wear the insoles
Bear in mind that the insoles
the better the shoe is insulated against cold, the longer you
can heat with a single battery charge.
♦ The trim marks
bottom of the insoles and serve only as a guide for trimming.
♦ Initially, trim the insoles
mine the required actual size by using an existing insole.
♦ Cut along the trim marks
heel and sides to your individual size.
CEB 2000 A1
are ca. 4 mm thick and that
for different shoe sizes are printed on the
slightly larger than needed. Deter-
and adjust the insole
GB
.
at the
47