Charging The Battery Pack - Crivit CEB 2000 A1 Bedienungsanleitung

NOTE
► In the final state the insole
and it not be possible for it to move in the shoe.

Charging the battery pack

The battery packs
ter . For safe and faultless operation of the appliance with the
electrical connection, observe the following instructions:
IMPORTANT
GB
► Before connecting the appliance, compare the connection
data (voltage and frequency) on the rating plate with that of
your mains power supply. This data must be compatible to
avoid possible damage to the device.
► Ensure that the mains power cable is not damaged and that
it has not been laid over hot surfaces and / or sharp edges.
► Ensure that the mains power cable is not overtaut or kinked.
► Do not let the power cable hang over edges (trip wire effect).
♦ Plug the power adapter
that the battery packs
do not glow).
♦ Connect the connector plugs
the connection sockets
indicators
charged. The optimum charging time is a minimum of 6 hours
and a maximum of 8 hours.
♦ The battery packs
indicators
NOTE
► Frequent overcharging of the battery packs
8 hours) results in a reduction of both efficiency and
service lifetime.
► For longer storage periods (e.g. over the summer), the
battery packs
(charging time approx. 3 hours) to extend their service life.
48
are charged via the supplied power adap-
into a mains power socket. Ensure
are switched off (function indicators
of the battery packs
glow red and the battery packs
are fully charged when the function
glow green.
should be charged to half their capacity
should fill the entire foot bed
of the power adapter
CEB 2000 A1
with
. The function
are being
(over