Stiga VE30 Gebrauchsanweisung Seite 29

All manuals and user guides at all-guides.com
3 ASSEMBLY
To avoid injuries and damage to prop-
erty, do not use the machine until all the
measures in these instructions have
been carried out.
3.1 Handle
3.1.1 The handle's lower section
1. Install the cable holder (1:A) on the handle's lo-
wer section.
2. Press the handle's lower section (1:B) down
into the machine.
3. Lock the handle into position with the two sc-
rews (1:C).
3.1.2 The handle's intermediate sections
Install the handle's intermediate sections (2:D)
with two screws (2:F) and knobs (2:E).
3.1.3 The handle's upper section
Install the handle's upper section into its interme-
diate sections in accordance with fig. 3. Use the
two screws (3:F) and the knobs (3:E).
Note! Install the handle with the holes for the
start control located to the right.
3.2 Start control
Install the start control on the handle's upper secti-
on in accordance with fig. 4. Use the two screws
4:G.
Secure the cable to the handle with the two clamps
(3:M).
3.3 Collector
If the collector is installed in the wrong
way, there is a risk that it will interfere
with the rotating tool. Risk of damages
to the tool and collector.
See fig. 9.
Install the collector as follows:
1. Open the hatch according to fig. 5.
2. Insert the collector until its hooks fit into the
slots in the machine.
2. Lower the hatch until it rests against the collec-
tor.
ENGLISH
4 DESCRIPTION
4.1 Controls
4.1.1 Electric socket and relieving loop
The machine must be connected via an
earth leakage circuit breaker with fault
current 30 mA. There is otherwise a
risk of fatal electric shocks.
The connection cable is connected to the ma-
chine's electric socket (4:H). The cable must then
be secured in the relieving loop (3:A) before it
leaves the machine.
4.1.2 Start and stop control
Start:
1. Tilt the machine until the front wheels rise
about 5 cm from the ground.
2. Press in and hold the button (3:P)
3. Squeeze the handle (3:O).
4. Release the button (3:P).
5. Let the front wheels down.
Stop:
1. Release the handle (3:O).
4.1.3 Height adjustment
The spiral cutter can be set to 5 different height po-
sitions according to the table below.
Note! The left and the right lever shall be set to
the same height.
Change position as follows:
1. Pull out the lever (6:R+L).
2. Set the lever to the desired position.
EN
29