Exhaust Duct; Attaching The Flue Duct; Connecting The Appliance To The Power Supply - CONSTRUCTA CD639860 Gebrauchs- Und Montageanleitung

Finishing installation of the appliance
1. Drill an 8mm Øhole to a depth of 80mm for the safety screw
and press the wall plug flush into the wall. ¨
First remove the protective foil from the back of the appliance
2.
and, following installation, remove the foil completely.
Connect the appliance. ©
3.
Screw in the safety screw - and washer - and tighten all the
4.
screws. ª

Exhaust duct

Note: The device manufacturer does not assume any warranty
for complaints attributable to the pipe section.
The device achieves its optimum performance by means of a
■
short, straight exhaust air pipe and as large a pipe diameter
as possible.
As a result of long rough exhaust air pipes, many pipe bends
■
or pipe diameters that are smaller than 150 mm, the optimum
extraction performance is not achieved and fan noise is
increased.
The pipes or hoses for laying the exhaust air line must
■
consist of non-combustible material.
Round pipes
An inner diameter of 150 mm, but at least 120 mm, is
recommended.
Flat ducts
The inner cross-section must correspond to the diameter of the
round pipes.
dia. 150 mm ca. 177 cm
2
dia. 120 mm ca. 113 cm
2
Flat ducts should not have any sharp deflections.
■
Use sealing strips for deviating pipe diameters.
■

Connecting the appliance to the power supply

Connecting the air extractor
Note: If using an aluminium pipe, smooth the connection area
beforehand.
1. Attach the air extractor pipe directly to the air-pipe connector.
Connect to air extractor opening.
2.
Seal the joints appropriately.
3.
Connect the power supply
Plug the mains plug into the earthed socket.
1.
If a fixed connection is required, please follow the instructions
2.
in the Electrical Connection section.

Attaching the flue duct

:
Risk of injury!
Components inside the appliance may have sharp edges. Wear
protective gloves.
Separate the flue duct sections.
1.
To do this, remove the adhesive tape.
Remove the pieces of protective film from both flue duct
2.
sections.
Push one flue duct section into the other.
3.
Notes
To prevent scratches, lay paper over the edges of the outer
■
flue duct section to protect the surface.
The slots of the inner flue duct section should point
■
downwards.
Place the flue ducts sections on the appliance.
4.
Slide the inner flue duct section upwards, and attach it to the
5.
left and right sides of the retaining bracket. ¨
Slide the flue duct section down to engage it. ©
6.
7. Screw the flue duct section to the sides of the retaining
bracket using two screws. ª
Use two screws to fasten the outer flue duct section to the
8.
appliance from below. «
27